Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Why is A352 LCC Not Permitted in Section VIII, Div.1 ???

Status
Not open for further replies.
vonmister

vonmister

Mechanical
Joined
May 1, 2014
Messages
1
Location
US
Does anybbody know why A352 LCC Not Permitted in Section VIII, Div.1 ? In section 2 Part D Table 1A under "Applicability and Max. Temperature Limits" it is listed as "NP=Not Permitted". Is there a reason for this? Thank you in advance for your help.
 
Status
Not open for further replies.

Similar threads

Tmoose
  • Locked
  • Question Question
ANSI Standard tolerances - B4.1 - but not just cylindrical fits
Replies
0
Views
986
Tmoose
Tmoose
ShlomoB
  • Locked
  • Question Question
Adding the same balloon multiple times in a drawing (ANSI)
Replies
3
Views
3K
ewh
ewh
Bartonrj25
  • Locked
  • Question Question
Making section views from a detail view
Replies
2
Views
844
SnTMan
SnTMan
Mauro Nicoli
  • Locked
  • Question Question
ANSI 16.5
Replies
6
Views
1K
Mauro Nicoli
Mauro Nicoli
fabeljafla
  • Locked
  • Question Question
API Source Inspector Electrical Equipment (SIEE) help ............
Replies
0
Views
944
fabeljafla
fabeljafla

Part and Inventory Search

Sponsor

Back
Top