Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Who did the sheetmetal model on the front page?

  • Thread starter Thread starter biflic
  • Start date Start date
Status
Not open for further replies.
B

biflic

Guest
Quite impressive indeed! I have attempted odd geometry in the past and have always had to resort to manual layouts. Any details on your methodology would be greatly appreciated.
 
It was submitted to this site annonymously. Hopefully the original owner will confess. :-)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top