T
thilag1981
Guest
Hello Friends
Nx Version Nx 9 or Nx 11 both Teamcenter Integerated.
Nx Module Assembly
While replacing a component inside the Assy. Similar part with very very minor change (Same XY, YZ and XZ planes used with old and new parts) and change in non interface / mating places.
The constrains are broking, is there any way to avoid this.
Regards
thilag
Nx Version Nx 9 or Nx 11 both Teamcenter Integerated.
Nx Module Assembly
While replacing a component inside the Assy. Similar part with very very minor change (Same XY, YZ and XZ planes used with old and new parts) and change in non interface / mating places.
The constrains are broking, is there any way to avoid this.
Regards
thilag
