Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Where to measure underfill from when mismatch
- Thread starter kevlar49
- Start date
I'm with DekDee on this one. Check the mismatch/misalignment first, then worry about the underfill. I would also be concerned with the root side of the welded joint and the incomplete joint penetration resulting from the misalignment.
The thickness through the weld has to be at least equal to the thickness of the adjacent members provided the other criteria is within acceptable limits, i.e., misalignment, face reinforcement, melt through, etc.
Best regards - Al
The thickness through the weld has to be at least equal to the thickness of the adjacent members provided the other criteria is within acceptable limits, i.e., misalignment, face reinforcement, melt through, etc.
Best regards - Al
- Status
Similar threads
- Locked
- Question