Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

when to use set-on & when set through

Status
Not open for further replies.
ramsripavan

ramsripavan

Mechanical
Oct 15, 2015
4
how do they decide nozzle projection for a steamdrum
risers,downcomers, pre-heater, chemical dosing nozzles..etc..
how do they decide whether it is to be set-in, set-on or set through

Ramsri.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
This post should be moved to the "Boiler and Pressure Vessel" forum

You will get better answers there...

MJCronin
Sr. Process Engineer
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
  • Locked
  • Question
Estimating steam flow through heat trace
Replies
4
Views
2K
goutam_freelance
goutam_freelance
L
  • Solved
Dear all: what type of evaporatir should be used for caustic soda concentration up to 50%? Forced circulation or falling film? 4
Replies
10
Views
5K
pierreick
pierreick
BasakAbhishek
  • Locked
  • Question
Way to calculate HTC on tubesheet
Replies
5
Views
363
davefitz
davefitz
A
  • Locked
  • Question
Advice On U-Values In Thermal Junctions... I Think I'm Doing It Wrong
Replies
0
Views
656
Alpherbiuss
A
Robati2024
  • Locked
  • Question
How to calculate isentropic tempera 1
Replies
4
Views
470
PaoloPemi
PaoloPemi

Part and Inventory Search

Sponsor

Back
Top Bottom