Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

when the final selection of a press

Status
Not open for further replies.
MSPVIN

MSPVIN

Industrial
Joined
Oct 15, 2018
Messages
11
Location
US
when the final selection of a pressure relief valve is required, will the code allow you to make the selection using the ASME or API orifice area?
 
Sort by date Sort by votes
Yes, refer to API-520 and 526 for the PSV valve type design and sizing based on the process requirements.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

YuJie_PV
  • Question Question
some questions regarding the buckling analysis(5.4 of ASME VIII-2)
Replies
3
Views
10K
TGS4
TGS4
YuJie_PV
  • Locked
  • Question Question
the reason of the change with UW-11(a)(4)?
Replies
1
Views
618
XL83NL
XL83NL
R
  • Question Question
Exclusion From the Scope of ASME BPVC VIII-1 - water-based solution
Replies
4
Views
6K
goutam_freelance
goutam_freelance
MUHAMMAD FAHAD RANA
  • Locked
  • Question Question
WPS/PQR & Filler Wire Selection
Replies
4
Views
975
weldstan
weldstan
YuJie_PV
  • Locked
  • Question Question
Membrane or Membrane+Bending when assessing local failure protection per ASME VIII-2
Replies
8
Views
7K
YuJie_PV
YuJie_PV

Part and Inventory Search

Sponsor

Back
Top