Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wheel Stud Load Ratings

Status
Not open for further replies.
Toolingtek

Toolingtek

Mechanical
Joined
May 15, 2003
Messages
6
Location
US
When testing the shear strength of a automotive wheel stud fastner would the shear strength rating (128 KSI) be along the center axis. Is it a pull type test along the stud center line axis until it pulls in half?
 
Sort by date Sort by votes
If you are pulling along the center line axis you testing tensile strength. Shear strength is measured perpendicular to the center line axis.
 
Upvote 0 Downvote
Thanks, should have thought longer, long day. Yes shear / shearing action normal to C/L...Ultimate tensile measured through C/L.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Konstantin K
  • Locked
  • Question Question
Stud bolts to ASTM A320 Gr L7M - Decarburization test
Replies
1
Views
404
MFAMET
MFAMET
bjlasota
  • Locked
  • Question Question
Material Substitute for load bearing part
Replies
4
Views
677
TugboatEng
TugboatEng
mrfailure
  • Locked
  • Helpful tip Helpful tip
Vickers Indentation Loads For Use In Hardness Conversion Per ASTM E140
Replies
4
Views
476
EdStainless
EdStainless
m899nyc
  • Locked
  • Question Question
Metal on Metal Contact Movement OK if there is no load?
Replies
4
Views
319
m899nyc
m899nyc
rehanjamshed
  • Locked
  • Question Question
Effect of HRC on Hi-speed Failure load
Replies
2
Views
227
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top