Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What's wrong with this picture? 1

Status
Not open for further replies.

ContractorDave

Mechanical
Joined
Jan 16, 2007
Messages
364
Location
CA
One star for the obvious and two stars for the not so obvious with an explanation.

Regards
Dave
 
Well there you go. Maintenance on a dry system would see it flushed every five years to mitigate rust. There's a cost there too.

Dave
 
Personally, I would like to see an air dryer required on dry systems. Why should we be pumping moisture into the system via the compressor?
 
SD2. I am out here in Northern Colorado and we use anti freeze wherever we can. I agree that in most large scale situations a dry system can reduce the cost (especially with a listed tank)but we have found ways around that. All of the AHJ's in our area have accepted figure 7.6.3.1 with a loop and the 1/32 hole check valve without the tank. The reason being that the wet system it's attached to will act as the expansion chamber. Depending on the situation (new system vs addition/Tenant improvement) the upgrade from a double check to RPZ is typically cheaper than installing a dry system. We have also been known to install a small RPZ at the beginning on the anti freeze as opposed to a large RPZ at the riser.

Just as a side note. Most of the water districts in our area are accepting glycerin in the anti freeze without the addition of the RPZ as it is food grade and does not pose a threat to public health.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top