Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
What's the best standard to naming parts and components?
- Thread starter Blue2654
- Start date
ASME Y14.100
(section 5 in 2004 edition, non mandatory Appendix C gives even more)
Use ASME Y14.38 for standard abbreviations if necessary.
(section 5 in 2004 edition, non mandatory Appendix C gives even more)
Use ASME Y14.38 for standard abbreviations if necessary.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Thread starter
- #3
Just realize ASME Y14.100 doesn't go into great levels of detail, and doesn't show hundreds of examples.
However, it lays out basic principles and by using it with the terms in 14.38 as required it builds a reasonable guide.
However, it lays out basic principles and by using it with the terms in 14.38 as required it builds a reasonable guide.
Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
What is Engineering anyway: faq1088-1484
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question