piper08
Civil/Environmental
- Dec 3, 2008
- 2
I'm trying to figure out what this part may be from, it is beat up bad because it went through our horizontal wood grinder. If you have any thoughts or ideas, it would be much appreciated. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
What is this?
- Thread starter piper08
- Start date
- Status
Was this upstream in a mill?
Thomas J. Walz
Carbide Processors, Inc.
Good engineering starts with a Grainger Catalog.
Thomas J. Walz
Carbide Processors, Inc.
Good engineering starts with a Grainger Catalog.
- Thread starter
- #4
piper08
Civil/Environmental
- Dec 3, 2008
- 2
The part was inadvertently pushed into a brush pile and loaded into the grinder unknowingly. It looks as though it is some sort of pump casing, or bearing casing of some sort. Just trying to figure out what it is, to hopefully determine where we potentially picked it up at.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
