Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Thread starter
- #2
M
MrCATIA
Guest
Add them as Text, instead of Dimension.
They define the angle/slope/gradient of the planes by specifying the RISE:RUN (H dist : V dist)
They define the angle/slope/gradient of the planes by specifying the RISE:RUN (H dist : V dist)
- Thread starter
- #3
M
Mans
Guest
Hello, master
That's right
When I encounter a technical problem, I often refer everywhere to find a solution, if it even takes long for weeks. I never give up an unsolved matter unless I realize it is out of my knowledge boundary.
When I pose a question here or in other engineering or technical communities, I research about that issue everywhere simultaneously to find the solution sooner.
After I sent this question, I reviewed a variety of the rail sections until I found the answer of my question in one.
Of course, I didn't know its terms (Rise: Run) and learned it from you
Thank you a bunch
That's right
When I encounter a technical problem, I often refer everywhere to find a solution, if it even takes long for weeks. I never give up an unsolved matter unless I realize it is out of my knowledge boundary.
When I pose a question here or in other engineering or technical communities, I research about that issue everywhere simultaneously to find the solution sooner.
After I sent this question, I reviewed a variety of the rail sections until I found the answer of my question in one.
Of course, I didn't know its terms (Rise: Run) and learned it from you
Thank you a bunch
Attachments
Similar threads
- Locked
- Question
- Locked