Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the unit of power spectrum for a voltage signal?

Status
Not open for further replies.

onemilimeter

Electrical
Jul 25, 2009
54
GB
I've an Agilent 35670A Dynamic Signal Analyzer. A signal is attached to Channel-1. The unit of the signal measured by the analyzer is as follows:

Time Capture (time domain): Volt (V)
Linear Spectrum (frequency domain): Volt-RMS (Vrms)
Power Spectrum (frequency domain): Volt-RMS (Vrms)

However, some online articles, for example the following:
... show that for a voltage signal, the unit of the power spectrum of the signal is Volt-RMS squared (Vrms^2).

Which one is correct?

Thanks.
 
Replies continue below

Recommended for you

Power (watts) is proportional to voltage squared. Your meter is doing the conversion for you. While the proper unit is watts/Hz, or volt^2/Hz, your meter is translating it for you (to make it easier). There may be an option somewhere to change the units displayed.

This confusion came up long ago with photodetectors when looking at noise performance. Photodetectors convert convert optical power to current directly, so this is a square law conversion. To keep the relationship linear the wrong units are typically displayed.

John D
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top