Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the proper thread undercut value before plating?

Status
Not open for further replies.
kpenn

kpenn

Mechanical
Joined
May 15, 2001
Messages
1
Location
US
I have an M3 screw that is going to get plated with a total buildup of .00015-.00025" (.004-006mm)of silver plating. What would be the proper undercut value for this M3 thread screw and how is this value determined?

Any help would be very much appreciated.
Thanks
 
Status
Not open for further replies.

Similar threads

rollingcloud
  • Locked
  • Question Question
What is the most likely reason for the wear on the bolt's thread?
Replies
10
Views
819
mfgenggear
mfgenggear
FrancoisY
  • Locked
  • Question Question
What is this Material & Specification? Please help
Replies
4
Views
5K
FrancoisY
FrancoisY
K
  • Question Question
How to find the amount of precambering to be done before welding to avoid distortion?
Replies
9
Views
836
dtimberlake
D
EngTipsAccount1234
  • Locked
  • Question Question
Does a bolt in a threaded hole have a preload or clamping force? If not, what is keeping the joint together.
Replies
7
Views
3K
mfgenggear
mfgenggear
rollingcloud
  • Locked
  • Question Question
What would be the most likely cause of nut thread stripping?
2
Replies
22
Views
1K
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top