Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What does D,ALL, UY,PI/4 after CSYS,1 do ??

Status
Not open for further replies.
Champkkc

Champkkc

Mechanical
Joined
Dec 11, 2010
Messages
4
Location
US
I have a question regarding boundary condition in cylindrical coordinate system.

CASE: If I have selected a node and applied the following boundary condition.

CSYS,1
NSEL,S,NODE,,1
D,ALL,UY,PI/4
NROTAT,ALL
CSYS,0

Does the node rotate 45 degrees along the circle ? I have searched a lot for BC's in cylindrical coordinate system in ANSYS online but could not find them. I would appreciate if anyone could point me to tutorials if any ?
 
Status
Not open for further replies.

Similar threads

T
  • Question Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
5K
TOM1345
T
md_salem
  • Locked
  • Question Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
970
Stick.
Stick.
netsonicyxf
  • Locked
  • Question Question
APDL Optimization: There are too many levels of *Do
Replies
0
Views
321
netsonicyxf
netsonicyxf
andradesilva
  • Locked
  • Question Question
How to export to a text file results of analysis with material non-linearities, for all the substeps
Replies
0
Views
443
andradesilva
andradesilva
offroader10052
  • Locked
  • Question Question
Calculation on new intel processors. What kernels to specify in the CFX solver?
Replies
0
Views
182
offroader10052
offroader10052

Part and Inventory Search

Sponsor

Back
Top