Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Welding Procedure for Stellite Material
- Thread starter Rj87
- Start date
Can't really help you, but perhaps the following link might be of interest to you:
Try Kennametal Deloro
Louw De Jong
Kennametal Stellite
604 463-2140
ldejong@stellite.com
Louw is incredibly knowledgeable and helpful
Thomas J. Walz
Carbide Processors, Inc.
Good engineering starts with a Grainger Catalog.
Louw De Jong
Kennametal Stellite
604 463-2140
ldejong@stellite.com
Louw is incredibly knowledgeable and helpful
Thomas J. Walz
Carbide Processors, Inc.
Good engineering starts with a Grainger Catalog.
It has been close to 40 years since I have used this material, but in the past I have used it for hard facing Automobile engine valves, and edges of disposable punch dies made from mild steel.
The technique used then, was to use an oxy acetylene torch, heat the base metal to the point of decalescence then butter the Stellite onto the surface.
The part would then be cleaned up by grinding.
B.E.
You are judged not by what you know, but by what you can do.
The technique used then, was to use an oxy acetylene torch, heat the base metal to the point of decalescence then butter the Stellite onto the surface.
The part would then be cleaned up by grinding.
B.E.
You are judged not by what you know, but by what you can do.
- Status
Similar threads
- Solved
- Question
- Locked
- Question
