Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Welding CRS1018 to AISI 304

Status
Not open for further replies.
MadMango

MadMango

Mechanical
May 1, 2001
6,992
What is the recommended welding rod material to MIG or TIG these materials together? Ray Reynolds
Senior Designer
Read: faq731-376
"Probable impossibilities are to be preferred to improbable possibilities."
 
Replies continue below

Recommended for you

Sort by date Sort by votes
A typical filler metal would be ER309L, but this can vary based on the type of application, PHWT if any, intended use, etc.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S.G
  • Locked
  • Question
Welding L-80 Type-1 Tubing to AISI 4130 Hammer Union
Replies
1
Views
2K
jmec87
jmec87
metboss
  • Question
Welding Procedure Specification (WPS) for the base metal AISI 8630(weld overlay cladding
Replies
1
Views
149
weldstan
weldstan
John Jones
  • Locked
  • Question
WPS/WPQR 304/316
Replies
1
Views
1K
kingnero
kingnero
Spike2000
  • Question
tig welding tubing, fitting face perpendicular to tubing
Replies
14
Views
7K
Tmoose
Tmoose
SAEEDGH
  • Question
stud welding manufacture process
Replies
3
Views
302
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top Bottom