Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Welcome Screen 1
- Thread starter Trent5791
- Start date
-
1
- #2
Trent,
The customer default "Gateway -> General -> Part -> Change Displayed Part On Close" will display the previously displayed part instead of the welcome screen.
The "Window" menu item will give a list of the explicitly opened parts (which may be more useful than a list of all open parts in the case where assemblies had previously been displayed.) Or Window-> More... which provides Search and the list of parts might be an alternative perhaps?
HTH,
Joe
The customer default "Gateway -> General -> Part -> Change Displayed Part On Close" will display the previously displayed part instead of the welcome screen.
The "Window" menu item will give a list of the explicitly opened parts (which may be more useful than a list of all open parts in the case where assemblies had previously been displayed.) Or Window-> More... which provides Search and the list of parts might be an alternative perhaps?
HTH,
Joe
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
