COMMAND "WBLOCK" WILL OPERATE IN SOME DRAWINGS BUT NOT OTHERS. THE BLOCK DIALOG BLOCK WILL APPEAR BUT WILL NOT WRITE THE INFORMATION BACK TO THE HARD DRIVE. WHAT DOES IT TAKE TO RESOLVE THIS PROBLEM. USING 2000i, THIS PROBLEM IS NOT HAPPENING WITH EVERY DRAWING, JUST EVERY NOW AND THEN.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
WBLOCK 2000I
- Thread starter deer
- Start date
HELLO DEEEEEEEEEEEEER!!!!!!!!!!!!!!!
I don't know Your problem.
Some ideas:
· is the command"-wblock" (without dialogbox) working?
· the layers aren't locked?![[wink]](/data/assets/smilies/wink.gif "[wink] [wink]")
· Do You have enough authorization for all folders?
· Did You try "_audit"?
· "save as" is still working?
· what happend, if You save as R12.dxf, and try then the "_wblock"-command?
· Did You try to repair Your AC (repair folder on Your CD)
I don't know..., Lothar
I don't know Your problem.
Some ideas:
· is the command"-wblock" (without dialogbox) working?
· the layers aren't locked?
· Do You have enough authorization for all folders?
· Did You try "_audit"?
· "save as" is still working?
· what happend, if You save as R12.dxf, and try then the "_wblock"-command?
· Did You try to repair Your AC (repair folder on Your CD)
I don't know..., Lothar
- Status