Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Wave runup analysis 1
- Thread starter KMsalem
- Start date
-
1
- #2
Marinelogistics
Marine/Ocean
We have received reply from Eric france for slipway pull.
We have used winch capacity of 20tons but it has fail to pull the vessel.
However we have used two single sheave pulley blocks and made the pulling ropes as three falls.This has helped to pull the vessel up.
Now we are having 250 mm wheel diameter and if we increase the diameter to 500 mm then the pulling capacity by the winch will be reduced.
By how much percent it will be reduced?
We have used winch capacity of 20tons but it has fail to pull the vessel.
However we have used two single sheave pulley blocks and made the pulling ropes as three falls.This has helped to pull the vessel up.
Now we are having 250 mm wheel diameter and if we increase the diameter to 500 mm then the pulling capacity by the winch will be reduced.
By how much percent it will be reduced?
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question