WAVE Linking/publications in NX

[orlandoa11]

Hello all,

I am looking for some direction on the most effective/efficient/robust method for linking geometry between parts in an assembly. I have been a CATIA user for a long time and have grown accustomed to using publications to link features from one part to the next as inputs and outputs in an assembly. In NX, this single feature from CATIA seems to have multiple, if not many counterparts. I am consistently confused on what the best practice method is.

I would be grateful to learn more about the differences and intended uses for...

- WAVE Geometry Linker
- WAVE Interface Linker
- Product Interface
- General WAVE Relinker

If any context is necessary, the application is for automotive BIW design - relatively large assemblies

Thank you kindly in advance

 

[jerry1423]

You will probably get good results searching in YouTube each of the four bullet points that you mentioned.
I will try to get back to you when I have more time.

Jerry J.
UGV5-NX1899

 

[jerry1423]

Sorry about the delay getting back to you.
The first two are pdf's. The bottom ones are videos.

https://www.appliedcax.com/docs/por...-2018/NX-Assembly-WAVE-Link-Demo-and-Tips.pdf

https://www.swooshtech.com/2021/02/12/wave-geometry/

https://www.youtube.com/watch?v=EgZm91F7f8k

https://www.youtube.com/watch?v=EKP4McfOZAM

https://www.youtube.com/watch?v=oSzjKs4k4uE

https://www.youtube.com/watch?v=MrTbAOmrgjM

https://www.youtube.com/watch?v=rFfa9OFzyv8

Jerry J.
UGV5-NX1899