Justin007
Civil/Environmental
- Feb 20, 2013
- 1
Good Day,
I am new to WaterCAD and I would like to ask how I could run a certain amount of flow through an already constructed system.
For example, I have already plotted all the pipes, junctions and reservoirs (all with corresponding properties) and I want to run, let's say a flow of 3 cubic m/ sec through the system. Where do I input the 3cubic m/sec to run through the system and check if my system is ok?
In addition, how do I input the bends for pipes also (I just plotted the pipes but where do I put in that it bends in this certain location and others)?
Thanks guys!
I am new to WaterCAD and I would like to ask how I could run a certain amount of flow through an already constructed system.
For example, I have already plotted all the pipes, junctions and reservoirs (all with corresponding properties) and I want to run, let's say a flow of 3 cubic m/ sec through the system. Where do I input the 3cubic m/sec to run through the system and check if my system is ok?
In addition, how do I input the bends for pipes also (I just plotted the pipes but where do I put in that it bends in this certain location and others)?
Thanks guys!
