Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Warning Log 1

Status
Not open for further replies.

eit09

Civil/Environmental
Jul 8, 2009
183
US
Got A Warning Log Message In RISAFoundation "Bottom Cover Value Too Large. 25% of thickness used instead" Where does the 25% of thickness come from?
 
Replies continue below

Recommended for you

It's an internal restriction and was put there to prevent other errors that would arise when the user specifies bars with a relatively large cover in an extremely thin slab.

I should also point out that the program will allow for bars placed at the center of slab.... but, you have to specify this with a check box on the slab tab of the design rules.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Top