Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

VTVM versus DVM 2

Status
Not open for further replies.

borgunit

Mechanical
Joined
Jul 26, 2002
Messages
1,153
Location
US
Hi,
I hope this question is not too basic for this forum but I will ask anyway. I am doing a tune up on an old turntable I have and according to the service manual, I need to make measurements with a VTVM (vacuum-tube voltmeter). I own a Fluke 111 DVM, is there any reason why this can not work in place of the VTVM? What are the differences?

Thanks

JR

"Everybody is ignorant, only on different subjects." — Will Rogers
 
No problem - the Fluke 111 even has the 'analog' bar graph in case you're trying to follow a moving signal.

How many adjustments are there on a turntable ?
 
About a dozen for this one. It has dc voltage, arm return hall effect, quartz timing bias, motor regulator (direct drive), 33 1/3 and 45 speed adjustments, a few others...

"Everybody is ignorant, only on different subjects." — Will Rogers
 
I suspect that the significance of the VTVM requirement was related to impedance. The VTVM had high impedance, about 11 MOhm where the VOM of the era was low impedance. Without web searching characteristics on your Fluke I would bet that the impedance is higher than the VTVM.

John
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top