Has anyone experienced problems running View To Model on area filled/hatched artwork? We are experiencing issues on NX7.5 NX8.5 and NX9 where the fill either disappears randomly or randomly fills in the object completely after View To Model is ran. This is a process we run routinely in NX5 with no issues, see attachment for example.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
View To Model Error
- Thread starter CaseNTray
- Start date
Arkance/PhoeNX
Mechanical
Can't say I've seen it in relation to View to Model, but I know that a customer of ours saw a similar issue where the crosshatch would bleed out of the border or disappear when opening older (NX5) files.
In that case it turned out to be that 'Extracted Edges' was turned off for the view. Not sure it's the solution you're after but it's worth a try.
Anthony Galante
Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
In that case it turned out to be that 'Extracted Edges' was turned off for the view. Not sure it's the solution you're after but it's worth a try.
Anthony Galante
Senior Support Engineer
NX3 to NX10 with almost every MR (21versions)
- Status