Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

VGK for wings

Status
Not open for further replies.
jcmbl

jcmbl

New member
Joined
Oct 22, 2004
Messages
31
Location
GB
Does anyone have any experience using VGK for wings on Linux machines? At least some other softwares able to run in batch mode on Unix machines, for relatively simple wing geometries. Fluent is too slow.

I'd appreciate any help.

Suhoi
 
Status
Not open for further replies.

Similar threads

A
  • Question Question
Macro for "scanning" CATdrawing sheet
Replies
1
Views
8K
3DDave
3DDave
C
  • Locked
  • Question Question
Recommendations for CATIA geometry watertight checks
Replies
2
Views
5K
rb1957
rb1957
M
  • Locked
  • Question Question
Sealant tape for aircraft fuel tank
Replies
10
Views
6K
WKTaylor
WKTaylor
G
  • Question Question
Looking for the AMS equivalent of ASTM B221 (6061-T6)
Replies
7
Views
7K
Sparweb
Sparweb
Doezer99
  • Locked
  • Question Question
Calculating Strain Life Cycles for LCF calculations
Replies
3
Views
3K
LiftDivergence
LiftDivergence

Part and Inventory Search

Sponsor

Back
Top