Macro for "scanning" CATdrawing sheet

[aerostudent2618]

Hi everyone im a newbie to catia,

Problem statement:
Im doing this project where by its difficult to find where a specfic part is located in which sheet. The part can be located in different drawing sheets or only 1.

My potential solution: i was think of using vba codes to run a macro that would scan the sheet and extract the part number and its associated drawing sheet.

Help: i need advice or the code that would work, should be using BOM, or vba code is good? I really need your help.thankssss

 

[3DDave]

This in not forum section where Catia experts look to answer questions. There is a Catia section. See https://www.eng-tips.com/forums/dassault-catia-products.560/