Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Vector Surge Protection for Generators

Status
Not open for further replies.
DKB68

DKB68

Electrical
Joined
Feb 18, 2003
Messages
2
Location
AU
I require to calculate the torque applied to the rotor shaft, change in power, and change in rotor angle of a 46MVA 11kV 1500rpm salient pole synchronous generator for a 30deg vector shift in voltage while operating at full load.

Can anybody help?
 
Sort by date Sort by votes
This was in part my Masters Essay and research.
Yes I can help.
 
Upvote 0 Downvote
Fantastic DougMSOE!

If it was part of your Masters research then I assume you've done dynamic studies on such. I don't have MATLAB or any other simulation software.
Is there a more simplistic or static approach to get in the ball park?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

slavag
  • Locked
  • Question Question
78V/Vector Shift/Voltage Surge/Vector Surge protection in the Distribution Generation system
Replies
2
Views
1K
slavag
slavag
SA07
  • Question Question
To install black start generator for 2 power generators 45 MW
Replies
8
Views
15K
waross
waross
NickParker
  • Question Question
Diesel Generators - Parallel operation
Replies
0
Views
9K
NickParker
NickParker
fosrich
  • Locked
  • Question Question
Surge Protection Failure
Replies
6
Views
596
waross
waross
DrDrreeeaaa
  • Question Question
Testing Procedures - Transformer Protection, Bus Zone Protection, Feeder, Reactor
Replies
0
Views
3K
DrDrreeeaaa
DrDrreeeaaa

Part and Inventory Search

Sponsor

Back
Top