Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Variable Section Sweep Cut ... Along trajectory

  • Thread starter Thread starter camilia
  • Start date Start date
C

camilia

Guest
Hej I need to ask how it works with Variable section sweep along trajectory but end should be curved using a curved reference.....not planer end...
plz see the picture
 

Attachments

  • VSS_Question.jpg
    VSS_Question.jpg
    76.5 KB · Views: 31
If you are used to modelling with surfaces you can create your cut shape as a surface and merge it with a surface that represents the id of your part and then select the quilt and solidify/cut with the quilt which will cut the upstanding in your image but not gouge in.
 

Part and Inventory Search

Sponsor

Back
Top