Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Valve Selection 2

Status
Not open for further replies.

Rjuli

Industrial
Joined
May 19, 2005
Messages
2
Location
ID
How do you determine the differential pressure (P1 & P2) of valve for a new installation?
 
It's a little difficult to answer your question but in general terms, the inlet and outlet pressure for a valve is set by the engineer when they design the system. As you change the flow rate through the system, that changes the pressure losses and thus the pressure at the inlet and outlet of the control valve. Of course, if you change operating pressures in the system that will also affect the pressures the control valve will see.

Control valves don't 'create' a pressure drop, the system imposes the pressure drop on the control valve, it's a key difference.
 
Thanks for the prompt reply, but I still cannot find the answer.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top