Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UW-16. F Dimension 1

Status
Not open for further replies.
u236

u236

Mechanical
Joined
Jul 11, 2018
Messages
22
Location
IT
Hello Everybody,

The coupling welded with Figure UW-16.2 F are subjected under any standard or any requirement about the dimension?
In particular related to the portion into the shell?


Thanking all for the cooperation,

Best Regards,
 
Sort by date Sort by votes
Hi,
Follow the requirements of UW-16(f)(3).

Notice the note in left bottom side of that Figure, you must use Standard Fittings: ASME/ANSI or Manufacturer's Standard.
 
Upvote 0 Downvote
Perfect thankz
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

abangbikerz
  • Question Question
UW 12 Angle Joints
Replies
1
Views
4K
goutam_freelance
goutam_freelance
bck2ftr
  • Question Question
ASME B16.9 - factor f for proof test
Replies
3
Views
11K
goutam_freelance
goutam_freelance
YuJie_PV
  • Locked
  • Question Question
An ASME interpretation regarding UW-11(a)(5)(-b)
Replies
2
Views
2K
YuJie_PV
YuJie_PV
sshep7
  • Locked
  • Question Question
SA-53 E/B used as a vessel shell Section - UW-12(e) UW-12(d), UW-11(a)(5)(b) and what JE to use
Replies
4
Views
641
david339933
david339933
YuJie_PV
  • Locked
  • Question Question
the reason of the change with UW-11(a)(4)?
Replies
1
Views
618
XL83NL
XL83NL

Part and Inventory Search

Sponsor

Back
Top