Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Using Manual Transfer Switch for service disconnect

Thread starter VladChiefns830
Start date Jul 3, 2018

Status: Not open for further replies.

Jul 3, 2018

VladChiefns830

Specifier/Regulator

Are there any pitfalls that I need to be aware of? The MTS is SUSE rated, will use class R fuses, will have a neutral bar-terminal. 120/208 single phase.

I am assuming that (in general) the power companies will allow the configuration...??

any thoughts?