Using Check-Mate to verify if holes are aligned

[Kraftliner]

Is it possible to use Check-Mate to verify if two or several holes have aligned center lines? Possibly by finding all center lines with endpoints within a given range and checking in these center lines are aligned? I realize there is no OOTB check for this, but are there functions that would enable writing a custom check that works in this way? Does anyone have experience of a check that works in a similar way?

 

[Kraftliner]

Two or several holes of different parts in an assembly that is....

 

[cubalibre000]

DFM Pro has it.

http://dfmpro.geometricglobal.com/products/userdetails.aspx?download=1&productid=94&RID=0

Thank you...

Using NX 8 and TC9.1

 

[Kraftliner]

Thank you, Cubalibre00