alanled9999
Mechanical
b]bold[/b]I want to use a block as a mold tool to make cavities etc. Im having trouble, do I insert the block into the drawing, position it and then subtract block from model?? any help would be great.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
USING A BLOCK AS A MOLD TOOL
- Thread starter alanled9999
- Start date
- Status
loosestring
Civil/Environmental
Sure. Give it a shot. You can always UNDO if you get undesired results.
- Status
Similar threads
- Locked
- Question