Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Use of WB 36 pipes for boiler application
- Thread starter tamal1475
- Start date
See Code Case 2353 for Section I. Based on this Code Case you can use WB36-pipes (not plates!) but you have to purchase, design, weld, postweld heat treat etc. according to this Code Case. There are quite many special requirements for manufacturing when using this grade.
Actually this material can be found in SA-335 as grade P36 but accepted for boiler use only via referred Code Case. And advantages of using this material are not so big as when EN-standard is followed because of ASME's higher safety factor to tensile strength.
Actually this material can be found in SA-335 as grade P36 but accepted for boiler use only via referred Code Case. And advantages of using this material are not so big as when EN-standard is followed because of ASME's higher safety factor to tensile strength.
- Status
Similar threads
- Question
- Locked
- Question
