Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Use of threaded rod as bolt material

Status
Not open for further replies.

NDT3RICH

Petroleum
Joined
Aug 19, 2015
Messages
12
Location
US
May B7 threaded rod be used as cut to length ASTM A 193 stud material?
 
Well, what are the material spec's for strength for B7 and for ASTM A 193?

(Let's assume the two threaded rods are cut to the same dimensions. )
 
NDT3RICH, ideally you'd want to transfer markings to the cut end(s) if for Code use.

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand
 
Yes. We do this all the time. Engrave the end with the grade for future reference.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top