I am looking to test a ether based urethane film to ASTM E 84 but before spending $1000 for the test would like to know if it will have a flame spread of less than 25% - I researched on the web but could not find where one had been tested and reported on. Any ideas on the chance of it passing?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
urethane flame spread
- Thread starter mesadave
- Start date
Similar threads
