Is there anyway that you can do an update on a drawing that uses a saved view? For example I create a view in Modeler. Go to drawing insert that view. Then I decide it's not the right angle for the view so change the view and save it over the previous one. Now when I go back to the drawing I have to re create the view. Is there anyway that I can just have it update the view to the new orientation without having to recreate?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Updating Save View in Drawing
- Thread starter UKIDIOT
- Start date
JohnRBaker
Mechanical
The drafting use of a so-called 'modling view' is only of an instaineous nature. That is, it uses the orientation of the modeling view to define the orientation of the drawing view, but there is no saved relationship between these aspects of the view and there was never any intention that there be, so it's working as designed.
John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA
John R. Baker, P.E.
Product "Evangelist"
NX Product Line
UGS Corp
Cypress, CA
- Status
Similar threads
