Has anybody had the update function vanish after a change? I changed one dimension, then exited the sketch, the part turned red, and then I looked for the little blueish update whirlwind thingy symbol in my bottom left corner of the bottom toolbar, and it was gone! I also looked in the pull down menu under edit, where is usually sits, and it was grayed out, and ctrl U also did not work. Does this sound familiar to anybody? Have you found out what to do next?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Update Disappears
- Thread starter descatia
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question