Unused parts in assemblies

[MIKE VALENTINE]

Hi, First time poster, I tried to use the search function on this thread with no luck. I can't figure out an easy way to find and delete unused parts left over after deleting configuration from an assembly. I have parts left over that aren't being used in any of my configurations/assemblies. But I'm finding it difficult to find which parts they are and deleting them. I want to reduce to file size and just clean them up.
Thanks in advance
Mike

 

[WBORGELT]

hi, first time poster, i tried to use the search function on this thread with no luck. I can't figure out an easy way to find and delete unused parts left over after deleting configuration from an assembly. I have parts left over that aren't being used in any of my configurations/assemblies. But i'm finding it difficult to find which parts they are and deleting them. I want to reduce to file size and just clean them up.
Thanks in advance
mike

used pack & go save to new folder
you will have all your parts you want in the new folder
the old folder a can delete

 

[MIKE VALENTINE]

WBORGELT, Thanks for the responce, but if I use Pack and Go I won't be able to get it back into my PDM software as the same part number.