Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Unknown update? (!)

Status
Not open for further replies.

Wittenborn

Aerospace
Joined
Jun 5, 2003
Messages
151
Location
US
I am working in an assembly with a ton of parts and a few subassemblies. I have an indication that there is a part or parts that are out of date and need to be updated.

I go to update the session, and NX grinds away, updating what seems like every part under the sun. When it is done, I STILL have a (!) in the title bar of NX, indicating that a part is still needs to be updated.

Is there a way I can look at the Assembly Navigator and see which part specifically is out of date?

Sorry for such a fundamental question, but this is driving me nuts, and I'm affraid that when I do get the part updated, I'll end up with a bunch of errors throughout my assembly...



Regards,
Grant
Aerospace Engineer
 
That figures... should have searched for (!).

Sorry for the duplicate posts.

Regards,
Grant
Aerospace Engineer
 
Not a problem Grant....I hope you're able to make some sense out of it.

Tim Flater
Senior Designer
Enkei America, Inc.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top