Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

units config

  • Thread starter Thread starter andrepinus
  • Start date Start date
Status
Not open for further replies.
A

andrepinus

Guest
Hi

I'm a new user and my problem is configuring units in mmetc but I don't know what config.pro I have to use because I found ProE already installed in my pc in the office.

Another question is if there is a list of key word needed to set all parameters of ProE.



Thank you

Andrea
 
Look under set up in the part menu...
 
http://utopia.knoware.nl/~ocorten/UTIL/2001_allopt.htm



There you will find a loot of commands for configuring ProE. Much of them (hidden) try to not use. You set up your units in your Config.pro file with command like this



pro_unit_length unit_mm

pro_unit_mass UNIT_GRAM



But also when starting work on new part or assembly don
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top