I have a sub assembly of a sliding rail which I use for slide-out drawers and the like. When I create an assembly of a drawer, I use (2) sliding rails. My drawer assembly BOM will show (2) rails. Since they are purchased in pairs I'd like the BOM to show a quantity of (1) instead. Is there a way for me to change the "Unit Quantity" for each rail sub assembly to a value of "0.5"?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Unit Quantity in BIll of Materials
- Thread starter Jaydez
- Start date
Similar threads
- Locked
- Question