Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Uneven Fillet Welds
- Thread starter Stripper2
- Start date
DesignerMike
Mechanical
Yes, Fillet welds only.
Must be done in the weldment assembly though.
Welds are actually pretty poor in IV. Parts must be touching, and flush. (their supposed to be working on gap, bevel welds etc) Choose fillet weld (not cosmetic) Pick the two faces to weld, chick the "arrow side" tab, and their you can set the size of the weld (X" x Y") and decide if you want a stitch weld (X" length every Y") AND set the contour shape.
It is pretty limited though and basically just looks pretty.
Must be done in the weldment assembly though.
Welds are actually pretty poor in IV. Parts must be touching, and flush. (their supposed to be working on gap, bevel welds etc) Choose fillet weld (not cosmetic) Pick the two faces to weld, chick the "arrow side" tab, and their you can set the size of the weld (X" x Y") and decide if you want a stitch weld (X" length every Y") AND set the contour shape.
It is pretty limited though and basically just looks pretty.
- Status
Similar threads