Beorges
Chemical
- Sep 11, 2009
- 12
I working to troubleshoot an Undercure NR Oring with Injection Molding,
Any suggestion on potential root cause with the Mold Tool Sprue, Gates, Cold deck.
From what i read, mostly this issue is caused by process parameters (Time Pressure Temp), or compounding.
But what about the tool itself, this was producing goog parts after, so, what migh have change ??
Can this undercure spot, be cause by a tool issue ??
Any suggestion on potential root cause with the Mold Tool Sprue, Gates, Cold deck.
From what i read, mostly this issue is caused by process parameters (Time Pressure Temp), or compounding.
But what about the tool itself, this was producing goog parts after, so, what migh have change ??
Can this undercure spot, be cause by a tool issue ??