Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UGNX and GM toolkit

Status
Not open for further replies.
bendall

bendall

Automotive
Joined
Mar 12, 2003
Messages
5
Location
CA
Hello everyone, after installing UGNX and the GM toolkit, I have noticed that GM Launch opens and UGNX must be opened via GM Launch. Does anyone know if there's a way to automate this so GM Launch selects UGNX automatically? Thanks in advance for any input.

Al
 
Sort by date Sort by votes
You should post this in the EDS (Unigraphics): Unigraphics forum. This is for Solid Edge.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

J
  • Locked
  • Question Question
VBA to Pull Total Surface Area and Volume for a Part of an Assembly?
Replies
0
Views
1K
jdconnel
J
bgriesel
  • Locked
  • Question Question
Dimension question and show surfaces default question
Replies
3
Views
423
bshand
bshand
kab343
  • Locked
  • Question Question
ST3 on Windows 8 and 10 - Question
Replies
3
Views
377
bshand
bshand
Larsen321
  • Locked
  • Question Question
3D Connexion and Solid Edge ST7
Replies
0
Views
156
Larsen321
Larsen321
berndtsl
  • Locked
  • Question Question
Copy and paste .dft used in assembly
Replies
2
Views
261
berndtsl
berndtsl

Part and Inventory Search

Sponsor

Back
Top