UGNX 3.0.5.3 Maintenance release 1

[modbob]

Hello,

I am still running NX Version 3. I know it is old ! I was wondering if anyone had maintenance release 3.0.5.3 they could send me.
I finally upgraded from XP to Windows 7 and apparently this maintenance release fixes the graphics error I get?

Thanks !

 

[NutAce]

I would say you can download it from Siemens download site...
If you have a legit version of NX then you can also get a webkey...
With that you can download it for free.

I don't think anyone here will provide you that update without knowing if you have a legal version of NX

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX11 / TC11

 

[JohnRBaker]

Even if you DO have a legitimate copy of NX software, the ONLY place that you can legally get an update is from Siemens PLM or one of their licensed distributors/partners.

John R. Baker, P.E. (ret)
EX-Product 'Evangelist'
Irvine, CA
Siemens PLM:
UG/NX Museum:

The secret of life is not finding someone to live with
It's finding someone you can't live without

 

[markrief]

I don't believe unsupported versions are available for download anymore. You would need to make a request through GTAC, if you are under maintenance.

Mark Rief
NX CAM Customer Success
Siemens PLM Software

 

[modbob]

Thanks For the input. The NX3 and NX4 software I have is legitimate. I have not kept up on my monthly maintenance.
I believe I would need to be paying maintenance in order to get a web key.
I could back pay the maintenance, however, the cost would be too much.

Thanks again for the advice.