Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
UG NX user new to SW - help with expressions please
- Thread starter rattler
- Start date
Read this:
- Thread starter
- #4
rattler,
Welcome to the Solidworks forum. The folks here are very helpful, and are very detailed in answering your questions. Good luck with the Solidworks (aka SW) software. I'm sure you'll enjoy it. There are a lot of aches and pains with SW, just like any other CAD software's, like UG NX.
Best,
Colin Fitzpatrick (aka Macduff)
Mechanical Designer
Solidworks 2008 SP 4.0
Dell 490 XP Pro SP 2
Xeon CPU 3.00 GHz 3.00 GB of RAM
nVida Quadro FX 3450 512 MB
3D Connexion-SpaceExplorer
Welcome to the Solidworks forum. The folks here are very helpful, and are very detailed in answering your questions. Good luck with the Solidworks (aka SW) software. I'm sure you'll enjoy it. There are a lot of aches and pains with SW, just like any other CAD software's, like UG NX.
Best,
Colin Fitzpatrick (aka Macduff)
Mechanical Designer
Solidworks 2008 SP 4.0
Dell 490 XP Pro SP 2
Xeon CPU 3.00 GHz 3.00 GB of RAM
nVida Quadro FX 3450 512 MB
3D Connexion-SpaceExplorer
- Status