Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Ug-34 (m)
- Thread starter fjodor
- Start date
abuanaselmasry
Mechanical
Nice question that I don't have a reply for 
However, I do believe that U-2 (g) will be applicable in this case.
There are also other questions related to sketches like (m).
What should be the shell thickness? Is the minimum thickness under the retaining ring? I think no. It should be the original thickness.
What is the sealing element between shell and flat head, between the outer surface of head and shell, or between the ring and (head & Shell)?
Let's see the replies.
Regards,
M.Salaheldin
Static Equipment Mechanical Design Engineer
However, I do believe that U-2 (g) will be applicable in this case.
There are also other questions related to sketches like (m).
What should be the shell thickness? Is the minimum thickness under the retaining ring? I think no. It should be the original thickness.
What is the sealing element between shell and flat head, between the outer surface of head and shell, or between the ring and (head & Shell)?
Let's see the replies.
Regards,
M.Salaheldin
Static Equipment Mechanical Design Engineer
- Status
Similar threads
- Locked
- Question