RTSRI
Mechanical
- Oct 31, 2008
- 4
Dear All
I am currently designing an ASME BPVC (U) pressure vessel, this vessel has an Cylidrical Acrylic (PMMA) viewport,(not classified as piping).
The design and fabrication of this window shall be according the PVHO-1 (section 2)
The PVHO-1 Introduction 1-1 states design,fabrication, inspection & stamping of the PVHO shall be in accordance with PVHO and ASME BPVC Section VIII. The vessel requires U-stamp.
If the viewport is designed,fabricated and tested acc the PVHO, is it allowed to be incorporated in the pressure vessel as meeting the BPVC, or should the window be accepted using UG-10.?, or is it not possible to get the vessel code compliant and stamped?
I am currently designing an ASME BPVC (U) pressure vessel, this vessel has an Cylidrical Acrylic (PMMA) viewport,(not classified as piping).
The design and fabrication of this window shall be according the PVHO-1 (section 2)
The PVHO-1 Introduction 1-1 states design,fabrication, inspection & stamping of the PVHO shall be in accordance with PVHO and ASME BPVC Section VIII. The vessel requires U-stamp.
If the viewport is designed,fabricated and tested acc the PVHO, is it allowed to be incorporated in the pressure vessel as meeting the BPVC, or should the window be accepted using UG-10.?, or is it not possible to get the vessel code compliant and stamped?