Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UDL over the Cylinder

Status
Not open for further replies.
jalaram25

jalaram25

Mechanical
Joined
Oct 14, 2006
Messages
1
I guys i am new to this forum

Pleae help me out i am stuck at the one problem for last week and i found this forum through internet

My problem is How to apply the UDL load over the cylinder is anybody know the solution to this problem

I didn't find the option for the UDL load over the cylider in CosmosWorks Static analysis

Please help me out
 
Status
Not open for further replies.

Similar threads

oharag11
  • Locked
  • Question Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
989
oharag11
oharag11
seraph3333
  • Locked
  • Question Question
IR LED solidworks thermal simulation unexpected extreme low temperature problem
Replies
2
Views
330
seraph3333
seraph3333
Denny Gibson
  • Locked
  • Question Question
SolidWorks 2018 Simulation: Simultaneous solution of mechanical and thermal stresses?
Replies
1
Views
312
FEA way
FEA way
Dlerner
  • Locked
  • Question Question
How to make an angled cut for the head of a pin
Replies
2
Views
429
RobWard
RobWard
Aravand
  • Locked
  • Question Question
2D sketch of the cross-section of a 3D part
Replies
1
Views
671
Mustaine3
Mustaine3

Part and Inventory Search

Sponsor

Back
Top